Other Brands
1/4" Round Wick for Kerosene Lamps - R514
This is 12" of 100% natural cotton wick for Kerosene oil lamps. Used in some models of Handlan lamps that use the round 1/4" wick similar to this one:
427 Pump Cup - S82
Smaller diameter leather pump cup for the model 427 lantern. Measures roughly 3/4" at it's widest point.
A fellow collector has shared with us that it will also fit the Akron 107 with a built on pump.
- Free Shipping
AGM 3016 Decal - D80
Decal for the AGM model 3016 Lantern. This decal is the waterslide type - not peel and stick.
Click on the "Description" under the photo to see the installation instructions.
AGM Burner Tube - E1145
I believe these are burner tubes for an AGM double mantle lantern. They are 2 7/8 inches long. Roughly the same diameter as Coleman burner tubes. Made of steel.
AGM Iron Generator - E1287
I believe these generators are for an AGM iron. They measure 4 inches long.
AGM Stove Porcelain Black Knob Used - E1209
This is a used knob. I believe this is one of the porcelain knobs for the old AGM kitchen or cabin stoves. Just a hollow star shaped knob. There are no threads on the inside and I am not sure how they were held on. Made of porcelain. Has a diameter of about 1 7/8 inches.
AGM Stove Porcelain Cream Knob Used - E1361
This is a used knob. I believe this is one of the porcelain knobs for the old AGM kitchen or cabin stoves. Just a hollow star shaped knob. There are no threads on the inside and I am not sure how they were held on. Made of porcelain. Has a diameter of about 1 7/8 inches.
AGM Stove Porcelain White Knob Used - E1362
This is a used knob. I believe this is one of the porcelain knobs for the old AGM kitchen or cabin stoves. Just a hollow star shaped knob. There are no threads on the inside and I am not sure how they were held on. Made of porcelain. Has a diameter of about 1 7/8 inches.
- Free Shipping
Akron Cap Gasket - S55
Cap gasket for Akron lanterns. Outside diameter is 5/8 of an inch. Inside diameter is 3/8 of an inch. Thickness is 1/8 inch.
Akron Iron Generator, New - E1618
We are pretty sure this is for an Akron Diamond Iron. Please check measurements.
Akron Lamp Generator - E1393
This is a generator for a Akron lamp iron. The body measures a little over 3 3/4 inches long. Has what looks more like a gear on the tip cleaner rod than threads. If you know the application, please share.
Bail Handle Unknown, Small - E1605
This is a used bail handle for a non Coleman made lantern. It is approximately 5-3/4" inches wide is approximately 5-3/4" inches high.
Bail Wrap Protector Black - R513
This is 12 inches of new black plastic bail wrap to protect the fount of any lantern. The size of these are small enough where it stays put after installation and will not slide around easily. 12" is enough to use on two to three lantern bails.
Bail Wrap Protector Clear - R512
This is 12 inches of new clear plastic bail wrap to protect the fount of any lantern. The size of these are small enough where it stays put after installation and will not slide around easily. 12" is enough to use on two to three lantern bails.
- Free Shipping
Cap Gasket HGP - S50
This is a large filler cap gasket for the Handy Gas Plants. It also works for the Tilley R1 heater.
- Free Shipping
- Free Shipping
Duo Therm Fuse Holder - E1001
Only 1 left in stockDuo therm Replacement Fuse Holder for RV furnaces. Fits duo therm furnace series 659 and 660.
Dura Camp Burner Assembly - E1295
New old stock burner assembly for the double mantle Dura Camp lantern.
- New!
Filler Cap 3 Piece AGM Used - E1634
Used AGM Cap. Has a steel screw and new filler cap gasket. This filler cap has the AGM hole in top. Shows signs of wear. Could be any combination of the following; wrench marks, oxidization, or fading.
Generator AGM Kamplite LRL21 - R400
Reproduction generator for the AGM model LRL21, LRL21A, LRL22, KL2, and JC Higgins model 710.7400, 710.74001 lanterns. Part number on JC Higgins parts diagram is 7110 - Generator Assembly
Generator Kamplite Inverted - R403
Reproduction inverted generator for the AGM Kamplite inverted lanterns. Fits models IL1, IL11, and Thermos models 8319, 8321.
Generator Lantern - No Wire - E1389
Thermos generator for inverted lantern models 8319 and 8321. Also fits Kamplite and JC Higgins inverted lanterns. May show signs of tarnish but is new old stock. New generator includes new gas tip, spring, BUT DOES NOT HAVE a tip cleaning wire.
Generator Stove - E1507
Thermos generator for models 8489, 8490, 8491 stoves. New generator includes new gas tip, spring, and tip cleaning wire.
Generator Sunshine Safety Q99 - R404
Reproduction generator for the Sunshine Safety lanterns and lamps. Similar to the Coleman Q99 but has a different nut. Will not work on Coleman lanterns and lamps.
Globe 990 - G171
The Canadian 990 globe was made to fit the model 331 lantern. Does not fit any other gas lantern model. Very rare globe to find these days. Will also fit the Thermos lantern models 8311 and 8312.
Globe Century 8939 - G31
This horizontally striped frosted globe is approximately 3 7/8 inches tall and has a 4 3/8 inch diameter.
- Free Shipping
Bestsellers
- Free Shipping
- Free Shipping
- Free Shipping