Stoves

Valve Assembly for the model 502 stove without fuel pickup tube. 

This is a new old stock pre-heater valve for the M2 military stove. Does not have the valve stem or wheel (knob). 

This is a used latch that was used on many stoves. Known to fit 413G. It may fit others.

Burner fillers for the 940-365 master burner.

Used direction disk for some Canadian stoves.

Valve stem

Generator tube only for the model 950 generator.

Unknown Coleman valve and generator. I can't figure out what this fits or a part number for it. Measures 11 1/2 inches long.

Valve assembly

Gas tip

Pre Heater Stem Assembly for the Marine Stove

This is a used pip holder cup for the M1950 stove pump. Comes with a new rubber pip.

This is a cap for the end of the M1950 pump. This screws into the bottom of the pump.

NOS valve minus the generator and valve wheel, for the model 425 series stoves. 

NOS Generator Coil. 

Fits 426B, 426C, 413E, 413F, 413G, 442, 442A and 443 stoves.

Stem (lighter) assembly. This was the last style used on the 500B Canadian Stove, will also work on the 500 and 500A. This is a rare part.

Used dark red knob for the 530 stove. Same as the 200a or 220 knob just a darker burgundy color.

Looks like it may have gotten a little too hot and burned (see photos)

This is a new Hollow wire with jamb nut for Coleman hollow wire systems. Length is 4ft and diameter is 3/16"

This is a new Hollow wire with jamb nut for Coleman hollow wire systems. Length is 4ft and diameter is 3/16"

This is a new Hollow wire with jamb nut for Coleman hollow wire systems. Length is 2ft and diameter is 3/16"

This is a new Hollow wire with jamb nut for Coleman hollow wire systems. Length is 5ft and diameter is 3/16"

Screw/Bolt for the burners on 5435A and 5435B Stoves. 2 are needed for both stoves.

Used Nut

These are Used and have a bit of rust on them. Fits stoves 3F, 3H, 413B, 413C, 413D, 418, 418B, 419, 420, 371, 371A. Does not come with the needle.  If your stove has been updated to a later valve style then this would not fit.

The needle and holder for this is part number 471-2381 HERE.

A whole new valve and gen would be part number 413B6601.  That is the valve that fits the 413E and 413G stoves.

Burner ring set used on the 952 range

Spring

Burner ring set for the model 396 and 397 master burner.

Needle valve asembly

Generator coil. Measures 7 1/4 inches long and the width is 7/32". Made of steel.

Fuel line for a Coleman stove. Don't have a part number for it. It measures approximately 6 7/16 inches long.

Gas tip

Gas tip.

Valve and generator.

Valve stem complete less needle for Generator 950-262

Valve Body

Strainer gasket.

Grate for 5404 and 5409 stoves. Good shape.

Gas tip.