428

This is the common Coleman check valve and air stem that fits most styles of lanterns and stoves made after 1946 and some before that date. Comes with the new O ring. If your part diagram calls for the 242B5381 or a 621-5361 check valve then this would be the correct part.

New brass one piece filler cap. Fits most all lanterns and stoves other than the model 242 lantern and 500 stove. 

Has gone in the past by part numbers 220C1401, and now 425A1405

Valve wheel screw. This is the later self taping screw. Fits most lanterns. Can be used where a 17-058 is needed.

Push on nut for end of pump rod. The small push on nut is used with leather pump cups.

Brand new Neoprene Pump Cup with a large push on nut made by Coleman. Fits pretty much all Coleman Stoves And Lanterns.

This is a used one piece filler cap. Paint is chipped. Has a new filler cap gasket. These are green. The shade of green and wear varies within this stock of used caps. 

Wind baffle support.

This filler cap is made by the Amish so you can pump up your lantern or stove with a bicycle pump. Fits most all styles of lanterns and stoves.

Pump Cup Neoprene for most lanterns

Stainless steel screw for the burner ring assembly on Coleman 2 and 3 burner suitcase stoves. Also same part as 413-130 but this is a slot screw instead of phillips.

Stainless steel filler cap screw for the 3 piece filler caps used on the 200A, 220B, 220C, 220D, 220E, 220F, 427 and similar sized filler caps.

Fits the cap number: 220C1401

Graphite ribbon. It is 1/4 inch wide and 12 inches long. It is scalloped to make it more flexible for wrapping. Works for tip cleaner assemblies or any other thing where the normal graphite packing won't fit. It is easily cut with a pair of scissors to fit whatever you might need.

Filler cap with lanyard for the small backpacking lanterns. Will also fit most other lantern and stoves that use the standard size filler cap.

This is a used one piece filler cap. Paint is chipped or missing in some spots. Gaskets have been replaced. 

One used wind baffle support in good working shape.

This is a used one piece filler cap. Paint is chipped or missing. Has a new gasket. 

Used steel filler cap for Coleman lanterns. Has a new gasket and ready for use. 

Used tank that fits the 414 and 428 stoves.
May have rust and chipped paint due to use. 

Valve body with valve stem - Used. Packing has not been replaced.

Valve body with with fuel/air tube and no stem - Used.