523

This is the common Coleman pump cup that fits most lanterns and stoves. 

Has a 7/8 inch diameter and is made of oiled leather.

New brass one piece filler cap. Fits most all lanterns and stoves other than the model 242 lantern and 500 stove. 

Has gone in the past by part numbers 220C1401, and now 425A1405

Pump Clip

Replacement Decal for 520 or 523 Military Stoves

This is a used one piece filler cap. Paint is chipped. Has a new filler cap gasket. These are green. The shade of green and wear varies within this stock of used caps. 

This is a reproduction aluminum funnel and chain for the Coleman military lantern and 530 stove.

This filler cap is made by the Amish so you can pump up your lantern or stove with a bicycle pump. Fits most all styles of lanterns and stoves.

Vaporizer screen for the model 530 stove. Would also work in other similar military stove vaporizers such as the M1950, 523 and 520. To install, roll between fingers to reduce diameter slightly, and insert into generator/vaporizer.

New old stock valve assembly for the model 520 and 523 stoves, comes with pre-heater cup and vaporizer.

This is the small part that attaches to the filler cap screw so you can hook the chain to it.

This is the ring that attaches to the collar of the lantern so you can hook a chain to it. Rings are stainless.

Stainless steel filler cap screw for the 3 piece filler caps used on the 200A, 220B, 220C, 220D, 220E, 220F, 427 and similar sized filler caps.

Fits the cap number: 220C1401

Used pump clip that fits most lanterns and stoves. It is used but in fine shape.

This is the gasket for the one piece filler caps. If your filler cap looks like the one pictured then this gasket is the correct one. 

If your filler cap has a screw in the center of it then this gasket will not work. 

The red filler cap is shown for illustration purposes only and is not included.

Graphite ribbon. It is 1/4 inch wide and 12 inches long. It is scalloped to make it more flexible for wrapping. Works for tip cleaner assemblies or any other thing where the normal graphite packing won't fit. It is easily cut with a pair of scissors to fit whatever you might need.

Filler cap with lanyard for the small backpacking lanterns. Will also fit most other lantern and stoves that use the standard size filler cap.

Parts tube for the M1941, M1942, 520 and 523 military stoves. 

Each contains a new vaporizer, gas tip, large packing, and 3 screens.

Parts tube for 520 and 523 military stoves. Contains a new vaporizer, gas tip, large packing, and 3 screens. The outer tube is rusty but the parts inside are fine.

Filler cap gasket for the model 523 military stove.

Parts tube for 520 and 523 military stoves. Contains a new vaporizer, gas tip, large packing, and 3 screens. The outer tube has a minor rust spot or two. The parts inside are fine.

This is a used one piece filler cap. Paint is chipped or missing in some spots. Gaskets have been replaced. 

This is a used one piece filler cap. Paint is chipped or missing. Has a new gasket. 

Used steel filler cap for Coleman lanterns. Has a new gasket and ready for use. 

This is the common Coleman pump cup that fits most lanterns and stoves. 

Has a 7/8 inch diameter and is made of dry leather.

Steel NOS Vaporizer screen for the model 530 stove. Would also work in other similar military stove vaporizers such as the M1950, 523 and 520. To install, roll between fingers to reduce diameter slightly, and insert into generator/vaporizer.

Empty parts tube for the M1941, M1942, 520 and 523 military stoves.