130G

This gasket is for the model 227, 427, 220/228 Slant lanterns, most winged style fuel caps, early 220B's, and other similar lanterns and lamps that have the older style cap insert.

It is the same outside diameter as the common three piece cap gasket but has a smaller inside hole. 

Old part number 115-1361. 

This will not seal they typical Coleman lantern cap.

Fits models Air O lantern, 327, 427, Slant 220 lanterns and CQ lamps

Reproduction lamp globe for the later style Coleman lamps. Real nice alternative to an expensive original. This globe measures 5 7/8 inches tall. The top rim opening has a 3 inch diameter. The bottom opening has a 3 5/16 inch diameter. It bulges out at the widest point to about 5 inches. Some people call this the 355 globe.

This is a reproduction lamp globe holder that allows you to use a common 220 size globe on your lamp. The original lamp globes are expensive and this is a great alternative. Burn your old lamps and no longer worry about breaking a rare globe. Globe is not included.

Original used green logo lamp globe made between 1935 and 1945. Logo is very lightly stamped as was common back in the old days. This globe measures 6 inches tall. The top rim opening has a 3 5/8 inch diameter. The bottom opening has a 3 1/2 inch diameter. It bulges out at the widest point to about 5 inches. 

Reproduction air stem for the Quicklite lanterns and lamps. Also fits the Model 16 heater.

Used figure 8 piece as used on the old Q style burner.

130 Lamp Decal

Fits models Air O lantern, 327, 427, Slant 220 lanterns and CQ lamps. Tip cleaning lever operates as it should. May or may not work as is - condition is unknown.

Original used green sunrise logo lamp globe. Although used it will have no defects. Logo is very lightly stamped as was common back in the old days. This globe measures 6 inches tall. The top rim opening has a 3 5/8 inch diameter. The bottom opening has a 3 1/2 inch diameter. It bulges out at the widest point to about 5 inches.

Canadian "Made in USA" Original used green sunrise logo lamp globe. Logo is very lightly stamped as was common back in the old days. This globe measures 6 inches tall. The top rim opening has a 3 5/8 inch diameter. The bottom opening has a 3 1/2 inch diameter. It bulges out at the widest point to about 5 inches.