130P

This gasket is for the model 227, 427, 220/228 Slant lanterns, most winged style fuel caps, early 220B's, and other similar lanterns and lamps that have the older style cap insert.

It is the same outside diameter as the common three piece cap gasket but has a smaller inside hole. 

Old part number 115-1361. 

This will not seal they typical Coleman lantern cap.

Fits models Air O lantern, 327, 427, Slant 220 lanterns and CQ lamps

Reproduction lamp globe for the later style Coleman lamps. Real nice alternative to an expensive original. This globe measures 5 7/8 inches tall. The top rim opening has a 3 inch diameter. The bottom opening has a 3 5/16 inch diameter. It bulges out at the widest point to about 5 inches. Some people call this the 355 globe.

This is a reproduction lamp globe holder that allows you to use a common 220 size globe on your lamp. The original lamp globes are expensive and this is a great alternative. Burn your old lamps and no longer worry about breaking a rare globe. Globe is not included.

Used frame hold down nut for the models 220/228B through 220/228F lanterns. Will show sings of light rust and wear but should work fine. Will also work on CQ Lamps to hold down the handle.

New Old Stock Air stem / thumb screw for filler plugs used on the old Quicklite lanterns and lamps. 

Reproduction air stem for the Quicklite lanterns and lamps. Also fits the Model 16 heater.

Used figure 8 piece as used on the old Q style burner.

130 Lamp Decal

Old Style R55 generator with the square nut.