Unknown Screen #1 - E1058
Unknown screen. Measures 1/2 inch in diameter. Very fine brass. Seems too fine to be for a burner screen. Came out of a lot of old AGM parts.
Unknown screen. Measures 1/2 inch in diameter. Very fine brass. Seems too fine to be for a burner screen. Came out of a lot of old AGM parts.
I believe these are burner tubes for an AGM double mantle lantern. They are 2 7/8 inches long. Roughly the same diameter as Coleman burner tubes. Made of steel.
Decal for the AGM model 3016 Lantern. This decal is the waterslide type - not peel and stick.
Click on the "Description" under the photo to see the installation instructions.
This is a used knob. I believe this is one of the porcelain knobs for the old AGM kitchen or cabin stoves. Just a hollow star shaped knob. There are no threads on the inside and I am not sure how they were held on. Made of porcelain. Has a diameter of about 1 7/8 inches.
This is a used knob. I believe this is one of the porcelain knobs for the old AGM kitchen or cabin stoves. Just a hollow star shaped knob. There are no threads on the inside and I am not sure how they were held on. Made of porcelain. Has a diameter of about 1 7/8 inches.
This is a reproduction tip cleaner stem for the model 220/228B through 220/228F lantern. Looks a little different that the original but is a great lower cost alternative to the original ones.
This also fits the AGM 2572 & Kamplite RL-3
Used pump for an AGM lantern. Not sure what model it is for but it measures 5 7/8 inches long.
This is a used knob. I believe this is one of the porcelain knobs for the old AGM kitchen or cabin stoves. Just a hollow star shaped knob. There are no threads on the inside and I am not sure how they were held on. Made of porcelain. Has a diameter of about 1 7/8 inches.
Used AGM Cap. Has a steel screw and new filler cap gasket. This filler cap has the AGM hole in top. Shows signs of wear. Could be any combination of the following; wrench marks, oxidization, or fading.
I believe these generators are for an AGM iron. They measure 4 inches long.
Generator for some model of AGM lantern. Measures only 1 9/16 inches long. Missing the tip cleaning needle.
Used generator for the model 8326 Thermos lantern. These fit also the Wards/Western Field Model 60-9523 and some AGM lanterns that use part number S7706.
These generators come in different conditions - all show wear and signs of use. The pricker rods are good in each and move freely.
Generator for some model of AGM lantern. Measures only 1 9/16 inches long.
Reproduction generator for the AGM model LRL21, LRL21A, LRL22, KL2, and JC Higgins model 710.7400, 710.74001 lanterns. Part number on JC Higgins parts diagram is 7110 - Generator Assembly
Generator for AGM lanterns. Measures 3 1/8 inches long. Fits the AGM model 3025 lantern. Thanks to Joe P. for this information.
This is a used globe for an AGM lantern. Marked heat resisting. The writing is faint as was common on these. These will also fit on 200a lanterns.