Unknown Screen #1 - E1058
Unknown screen. Measures 1/2 inch in diameter. Very fine brass. Seems too fine to be for a burner screen. Came out of a lot of old AGM parts.
Unknown screen. Measures 1/2 inch in diameter. Very fine brass. Seems too fine to be for a burner screen. Came out of a lot of old AGM parts.
This is a reproduction tip cleaner stem for the model 220/228B through 220/228F lantern. Looks a little different that the original but is a great lower cost alternative to the original ones.
This also fits the AGM 2572 & Kamplite RL-3
Used generator for the model 8326 Thermos lantern. These fit also the Wards/Western Field Model 60-9523 and some AGM lanterns that use part number S7706.
These generators come in different conditions - all show wear and signs of use. The pricker rods are good in each and move freely.
This is a used globe for an AGM lantern. Marked heat resisting. The writing is faint as was common on these. These will also fit on 200a lanterns.
Reproduction generator for the AGM model LRL21, LRL21A, LRL22, KL2, and JC Higgins model 710.7400, 710.74001 lanterns. Part number on JC Higgins parts diagram is 7110 - Generator Assembly
Used AGM Cap. Has a steel screw and new filler cap gasket. This filler cap has the AGM hole in top. Shows signs of wear. Could be any combination of the following; wrench marks, oxidization, or fading.
This is a used knob. I believe this is one of the porcelain knobs for the old AGM kitchen or cabin stoves. Just a hollow star shaped knob. There are no threads on the inside and I am not sure how they were held on. Made of porcelain. Has a diameter of about 1 7/8 inches.
This is a used knob. I believe this is one of the porcelain knobs for the old AGM kitchen or cabin stoves. Just a hollow star shaped knob. There are no threads on the inside and I am not sure how they were held on. Made of porcelain. Has a diameter of about 1 7/8 inches.
This is a used knob. I believe this is one of the porcelain knobs for the old AGM kitchen or cabin stoves. Just a hollow star shaped knob. There are no threads on the inside and I am not sure how they were held on. Made of porcelain. Has a diameter of about 1 7/8 inches.
Generator for AGM lanterns. Measures 3 1/8 inches long. Fits the AGM model 3025 lantern. Thanks to Joe P. for this information.
Used pump for an AGM lantern. Not sure what model it is for but it measures 5 7/8 inches long.
Generator for some model of AGM lantern. Measures only 1 9/16 inches long. Missing the tip cleaning needle.
Generator for some model of AGM lantern. Measures only 1 9/16 inches long.
I believe these generators are for an AGM iron. They measure 4 inches long.
I believe these are burner tubes for an AGM double mantle lantern. They are 2 7/8 inches long. Roughly the same diameter as Coleman burner tubes. Made of steel.
Decal for the AGM model 3016 Lantern. This decal is the waterslide type - not peel and stick.
Click on the "Description" under the photo to see the installation instructions.