Search

Vent rod for the Quick-Lite lanterns. It is 1 1/4 inches long.

Vent rod for the model 5114 propane lantern.

Reproduction vent rod for the model 236 and 237 lantern. Made of solid brass.

Shorter vent rod for models 220/228F through 220K

Longer vent rod for models 220/228B through 220/228E and 235.

This is a used mixing chamber. May or may not have a vent rod and air tube screw.

This is a used burner assembly that will fit models 220/228B through 220/228E. It will show signs of use but will be in good condition. Has the long vent rod for the taller vents. If you change the vent rod to a shorter one, (HERE) it would work fine for a 220F.

Reproduction nickel plated vent rod for the models 234, 242A, 242B, 242C, 247, 249, and similar style lanterns. Will not fit the Australian made 249 lantern.

Brass Pin for 242 or 242NL Lantern - will not fit other versions of the 242. This is secured directly to the 242 vent. This fits into the burner frame hole - It forms to the 242 vent and captures it permanently after you heat it and swedge it in place. See directions below. Comes with Steel rod to assist in the process.

Installing Pin into a 242 vent:

1. Position the steel shaft with the hole end up in a vise securely. 
2. Put the brass pin insert in the hole of the big shaft. 
3. Heat the small lip of the brass insert with a propane torch until it's a nice orange color, this will anneal it and make the brass softer so it won't crack when it's tapped over. 
4. Set the vent over the insert. 
5. Place a ball peen hammer or something with a similar on the heated lip of the pin.
6. Tap down with a hammer onto the center and gently tap it with another hammer to swedge it outward - continue until it's seated nicely in the vent.

You will notice the edges of the lip will fall away.

New reproduction vent rod for the 200A. This is the longer vent rod made for lanterns 1963 and earlier.

Reproduction 200A Vent Rod Bracket Short. Made to fit the 1963 and later 200A's with the lower profile vent.