Lanterns
242C Steel Collar, Used - E1245
This is a used steel collar for the model 242C lantern. Has a good amount of rust.
335 Fount, Used - F151
This is a used fount for the model 335 lantern. It is date stamped 1-75. It has surface rust, but no dents. Seems solid and the inside is not horrible.
Valve Stem Lamp, NOS - E1593
NOS valve stem with the fiber wheel for the early Coleman lamps. Will not fit lanterns. Fits model CQ, BQ, PQ, 117A, 118A, 119A lamps and others.
220 Lantern Reflector - LR4
Used Lantern light reflector. These are meant to hook into the lower burner frame holes on a 220 and then also the ball nut on top. Should fit all lanterns with similar burner frame holes. See photos. Lantern not included, just for demonstration purposes only.
This one is in very good condition.
NOS Burner Cap 220 Nickel Round - E1631
New nickel plated brass burner caps with round head. Fits most models of double mantle lantern and lamps.
Filler Cap, Burgundy - E1570
This is a used one piece filler cap off the Model 200A burgundy.
Comes with a new gasket that you will have to install.
- Free Shipping
Bail Cotter Pin, New - E1150
New cotter pin for the 220B, 235 and other early style bails. This tiny cotter pin may be a little long and will have to be trimmed, but the width is correct to pass through the bail holes.
Generator Nut, Reproduction - S124
Reproduction generator nut for all the model 200, 242, 243, 220, and 228 models.
- New!
Ball Nut 242 Canadian, Wrench Marks - E1393
Ball nut for the Canadian made 242, 247 and similar lanterns. This was also the ball nut that Coleman sold as a replacement ball nut in the US.
They will all show varying signs of wear/ wrench marks.
- New!
- New!
- New!
Lamp Fiber Handle, Used - E1167
This is a used lamp handle for the early lamps like the Model M and other Pre CQ Lamps. Some might show signs of wear. It is 4 3/4 inches long.
- New!
220 Vent, Black, New - V116
This is an original 220 Coleman vent. The black porcelain finish was custom done by Independence Porcelain Enamel (IPE). This is for the late 220F made after 1971 and also the G, H, K and J models. These fit on a wider burner frame, but will also fit on the early F with a smaller frame but will be a bit loose.
- New!
Tip Cleaner & Air Piece Assembly, Nickel - E1249
Nickel Tip Cleaner Assembly with air piece. Does not have the eccentric block.
- New!
Fuel and Air Tube, Nickel, Old Style - E1573
Fuel and air tube for lantern models 220/228B, 220BX, and 220/228C. Earliest style of fuel and air tube.