222A

Stud.

Used steel filler cap for Coleman lanterns. All will vary in wear.

Comes with a new gasket that you will have to install.

Used filler cap with lanyard for the small backpacking lanterns - in very nice shape. Will also fit most other lantern and stoves that use the standard size filler cap.  Comes with a new gasket that you will have to install.

This is a used one piece filler cap. Paint is chipped or missing. Comes with a new gasket that you will have to install.

Used filler cap that will fit most lanterns and stoves other than the model 242 lantern and 500 stove that have the smaller filler caps. 

These are all assorted colors that have missing paint, are tarnished or have been repainted and do not match the original color - photo is for illustration purposes only - comes with one filler cap and new gasket you will have to install.

NOS burner frame for the model 222 Peak 1 Lantern

New Generator for Model 226A700 and the 226-700. New generator includes new gas tip, spring, and tip cleaning wire.

Also known as part number 3000005088.

This also fits 222 models, but please read on. 

Coleman discontinued the 222 generator, and they recommend this as the replacement now. In practical use, people have found that it will work and work well, but the heat shield will need fabrication or if using  this on a 222, you should install a different heat shield set up out of a 226/229 lantern. The heat shields are not a part that can be ordered as they have been discontinued. This generator is wider/fatter than the original 222 generator and essentially conflicts with the heat shield. The part number for the heat shield is 5414-4605. 

NOS gas tip for Model A Lamps and possibly other early Torch-Lite Lamps.

New Reproduction Generator Needle for Model 222, 222A, 222B, 226 and the 229.

This is a used one piece filler cap off the Model 200A burgundy. 

Comes with a new gasket that you will have to install.